Epoxy Flake Floors in Arlington, TX

Epoxy flake floors, also called chip or broadcast floors, are the most popular choice for residential garages. Colored vinyl flakes are thrown into the wet base coat until the surface is covered, the excess is scraped and swept off once it cures, and a clear topcoat locks it in. The finished floor has a speckled, stone-like look and a slight texture underfoot. It is forgiving, practical and hard to tell apart from a granite countertop at a glance.

What the flakes actually do

The flakes are not just decoration. A solid-color glossy floor shows every footprint, tire track and bit of North Texas dust that blows in when the door is up; a flake floor hides most of it between cleanings. The flakes also add build, so the finished system is thicker than base and topcoat alone, and they leave a texture that is easier to walk on when the floor is wet. On older slabs, a full broadcast helps hide small surface flaws that remain after grinding and repair.

Full broadcast or partial?

In a full broadcast, flakes go down until the base coat is completely covered, which gives the most texture, the most hiding power and a uniform look. A partial broadcast scatters flakes over a solid-color base, so the color shows through. Partial uses fewer flakes and looks cleaner in a modern space, but it shows dust and wear more, and it is slicker. For a working garage we usually recommend full broadcast.

Choosing a blend

Flake blends mix several colors and come in different chip sizes. Small chips read as a fine granite; larger chips look bolder and hide more. Gray and tan blends are the most common in DFW garages because they hide red clay dust and tire marks, while darker blends show light dust more. We bring samples to the estimate so you can see them on your floor in your light, rather than picking from a screen.

Texture and the topcoat

The topcoat controls how the floor feels. One thicker topcoat over the flakes leaves a light orange-peel texture that grips well; a second coat makes it smoother and glossier, which looks good and mops easier but gives less traction. We help you pick the balance, and we can add an anti-slip additive near entry doors or steps.

Sun at the garage door

A lot of Arlington garages face the street, and some get hours of direct afternoon sun with the door open. Epoxy topcoats can amber in UV light, and on a flake floor that shows as a yellow cast over the lighter chips near the door. HomeGuide rates polyaspartic UV resistance as excellent and epoxy as poor to fair, so for sunny garages we usually topcoat a flake floor with polyaspartic.

Prep is the same as any coating

None of this matters if the base coat does not stick. Flake floors get the same diamond grinding, crack and spall repair and moisture check as any system we install. On clay-soil slabs that are still moving, a full broadcast is also the best at hiding a hairline crack if one comes back.